Inside the factory
Production process - from block to container
The six stages a Rongchengstone order passes through, and the check at each stage that keeps an approved sample and a landed container the same stone.
Every incoming block is logged, photographed and assessed for veining direction and colour drift before a single cut. Book-match sets are reserved at this stage.
Gangsaw cutting with resin-backed mesh and kiln drying for marble families; multi-wire lines for granite. Slab dimensions and mesh integrity are checked off the line.
Infrared bridge saws cut to the approved list at ±0.5 mm. Cut-sizes, edge details and panel sequence all trace back to the REF number.
Automated polishing lines run polished, honed, brushed and leathered schedules; flamed and bush-hammered passes are set per finish spec.
Each finished piece is checked under strong light for dimensions, colour range within the batch, surface defects and finish consistency before it earns a packing slot.
Approved pieces wait in indoor storage by order batch. Loading follows the packing plan - bundles crated, photographed against the packing list, container closed on camera.
What we check, in one line each
Quick answers
Veining review before cutting?
Yes - direction and colour drift are logged at intake, and book-match pairs are reserved before the saw runs.
Cutting tolerance?
±0.5 mm on infrared bridge saws, checked against the approved cutting list.
Who inspects each piece?
Our QC team, piece by piece, under strong light - and third-party inspection is welcome at any stage.
How is loading documented?
Every crated bundle is photographed against the packing list before the container closes.